Joined in 2023 
82 
63 About this deal
The division of a power distribution system into categories is based on the fact that a dangerous high-energy transient, such as a lightning strike or switching transient, will be attenuated or dampened as it travels through the impedance (ac resistance) of the system. The higher the category, the larger the prospective fault current available and the higher the voltage transients can be — peaking as high as 10,000 V for mains being measured at CAT III < 1500 V. Solar installations are Category III environments As a result, measurement instruments (such as multimeters) must be rated to resist higher voltages (for short periods of time) than the circuit’s intended working voltage. This is why the electrical measurement category is so crucial. Category II measurements are done on circuits linked to a low voltage source, often from a residential wall outlet, and pose a somewhat larger danger than CAT I measurements. This covers items such as hand tools and household appliances. The highest level of CAT available - this refers to testing anything that is connected directly to the source of power in a given building. Since there's a chance of arc flash and high levels of energy present, you MUST have a CAT IV device to test this form of equipment.
The provisions of this clause shall not apply to the service of any proceedings or other documents in any legal action. IMPORTANT NOTICE IN THE CASE OF MOTOR VEHICLES – Motor vehicles are not warranted as being roadworthy. Where available, motor vehicles will be sold with a current MOT test certificate, but the MOT certificate is only a statement that the motor vehicle complied with legal requirements on the date of the test. A current MOT test certificate does not confirm that a motor vehicle is roadworthy at the date of sale. Odometer readings are not verified and are not warranted. The Buyer undertakes that he will ensure that: i) confirm that you are authorised to provide these credit card details to the auctioneer and have sufficient funds available to complete the transaction. The dielectric tests for a CAT III 1000 V current clamp is 8000 V pk/7000 V rms. For CAT III 1500 V, it’s 10000 V pk/9700 V rms.
being a company) the holder of a qualifying charge over the Buyer's assets has become entitled to appoint or has appointed an administrative receiver. While a CAT IV certification isn’t required for most domestic electrical projects, it can be beneficial to utilize CAT IV rated meters to increase safety or simplify the meter and probe selection process. Why Measurement Category is Needed On primary overcurrent protection devices and ripple control units, this category refers to the point of installation or utility level readings.
the price offered by the Buyer at the fall of the hammer in a sale by public or online auction; and Voltage spikes occur all the time, even though the electricity provided by the power grid (mains electricity) is rated for a specific voltage. Voltage spikes can be caused by lightning strikes, sudden unloading, capacitors, and motors. Except as set out in these Conditions, no variation of this agreement, including the introduction of any additional terms and conditions, shall be effective unless it is in writing and signed by the Agent. The Agent shall be entitled to vary these Conditions at any time. The version of the Conditions current at the time that a Buyer requests Sale Details, registers or submits a bid, tender or offer will apply to all dealings on those Sale Details.If the Buyer has paid for but fails to collect the Lots by the Collection Deadline specified in the Sale Details then, except where such failure or delay is caused by a Force Majeure Event or the Agent's failure to comply with its obligations under the Contract:
Related:
Great Deal 
New Comment