Owatrol Textrol Clear 2.5lt

Product Information

Wet timber scrub off ground in dirt, while still wet apply Net-Trol Wood cleaner & Colour restorer 3) Leave for 10 – 20 minutes (do not allow to dry apply more Net-trol or damp with water mist) When first applied, Textrol will give the wood a rich, matt colour which will gradually lighten over time to the finished look. It is now available in 8 different colours for a range of looks all with premium protection. Why should I use Textrol? If your patio doors have not been finished with any varnish, wood oil, paint etc, then you would need to use Net-Trol clean and brighten the wood reviving the colour.

Textrol HES has a luxurious matt-sheen finish which enhances the grain and natural beauty of the wood. As it is penetrative and its place is not on the surface it will not peel or flake as it doesn’t form a film. Why use Textrol HES? NOTE: Owatrol Textrol is not a surface coating, its place is in the wood not on the surface. Owatrol Textrol protects by penetrating the wood, providing a rich matt finish. Always read the Textrol HES Product Information before using and follow the instructions carefully. Long-lasting natural-looking penetrating oil for all exterior woods. Developed to penetrate deep into the wood, Owatrol Textrol provides long-lasting protection against moisture damage, offers superior UV resistance, at the same time enhancing the woods natural beauty. Use as is. Do not thin. Stir can well before and during application. Apply a single liberal application of Owatrol Textrol HES working in the direction of the grain.Using a brush or roller apply a coat of Textrol and allow it to soak into the surface for 15-30 minutes.

Most cladding and vertical surfaces will only require touch up applications of Textrol. When areas treated with Textrol turn gray, clean with Net-trol and apply a single application of Textrol to replace material which has weathered out. Areas retaining good color do not need a maintenance application. Once the timber is saturated, brush out or wipe any excess product that has not penetrated within 15-30 minutes of applying the last application to avoid shiny spots. If you are collecting timber products please collect at the time bookedi.e. 9am collection would be 9am > 9:45am, this helps us have the product ready for your slot and reduces customer congestion. Surfaces must be clean, dry and free of dirt, grease, grime, mildew and previous coatings. Treat mildew with a 50/50 bleach/water solution. Scrub solution on to surface and allow to stand for 10-15 minutes; rinse thoroughly. After cleaning, allow wood to dry 2-3 days or until it has reached a moisture content of 18% or less before applying. Textrol Laboratories Inc.(formerly Textrol Inc.), is a world leader in Precision Yarn Tension Control Systems. Textrol Laboratories offers the most advanced Hysteresis Brakes and Permanent Magnet Brakes for tension control systems in the world. Our precision calibration methods give us the ability to build a world class Tension System for most of the Yarns, Strands, Ribbons, Etc. used in the industrial world.If none of those took your fancy, there are an endless number of different types of decorative fence panels, from curvy tops to castle styles you’re bound to find something right for you – do be aware though that these can be costly!

Solvent (oil or alkyd based finishes): Strip with Owatrol Dilunett neutralise with Owatrol Net-Trol. There are of course other options when choosing a finish for your wood, depending on the look you are trying to achieve. Before starting, test the color choice on a small area. Allow to dry to determine final color (remember that this color will lighten over a couple of months to the final color). Note:Do not create a film. Textrol HES is not a surface coating, its place is in the wood not on the surface. No need to apply to reverse of the board. For directions on surface preparation please refer to the technical sheet. Maintenance Deks Olje D1 is different from Textrol in that it can be used on new wood (with some surface preparation) if you are looking for an immediate protection. D1 is a saturating wood oil which gives a clear matt finish that enhances the natural beauty of the wood and is easy to maintain as just like Textrol it requires no sanding or stripping! It provides outstanding protection against damage by moisture and UV rays and can even be used on interior wood as well as exterior wood. D1 is available in 1 L, 2.5 L and 20 L containers and as a guide you will need approximately 1 L for every 1-4m² you need to cover.Please Note swatches are given as a guide only and are based on use for light coloured softwoods. Actual colour will depend on the type and age of the wood surface treated. Therefore, we recommend you always test a sample first before coating the entire surface. Restrictions Galette's highlights occurred early in camp before the hamstring injury flared up. cheap china jerseys Given that it has been so long since he has played, the coaching staff places more value in seeing Galette play in the preseason than, say, tight end Jordan Reed, who missed almost cheap nfl jerseys the first month with a toe injury.

Gary (Managing director at Owatrol UK) proclaims “Textrol is not a top coat, it is meant to be in the wood not on top. Textrol protects wood by making its way through the wood and creating a matt like finish.” Apply a single liberal application of Textrol HES working in the direction of the grain. After 15-30 minutes brush out any excess to improve penetration and give a uniform finish. Ensure you have cleaned the wood as detailed above and left it to dry for at least a couple of days Clean all tools and equipment with white spirits whilst still wet. If allowed to dry, remove with paint stripper. Textrol HES is a one-coat, penetrating oil finish for softwoods and European hardwoods. It has been developed to penetrate deep in to the wood with a high solids content which protects the timber against damage caused by the weather and UV rays.

Pallet agreements which are about to expire

To apply Textrol to weathered wood first ensure the wood is fully dry (preferably allow 2-3 completely dry days after cleaning) although we know this can be difficult to guarantee with the British weather! You can use a brush, roller or garden sprayer to apply the Textrol and you should apply an initial coat and allow 15-30 minutes for it to be absorbed into the wood. The important thing to remember about Textrol is that it should be applied wet-on-wet which means that you should not allow the surface of the wood to dry between coats. This is because Textrol’s place is in the wood and not on top – if you allow it to dry then the Textrol which has been absorbed will prevent the new coat form penetrating the wood! Shake or stir can well before use. Use as is. Do not dilute. Apply 1st coat of Owatrol Textrol and allow to penetrate into the wood (15-30 minutes). Apply 2nd application and allow to penetrate into the wood (15-30 minutes). If required repeat this procedure until the wood is saturated i.e. will accept no more oil. Once the timber is saturated, brush out or wipe up any excess product that has not penetrated within 15-30 minutes of applying the last application to avoid shiny spots. Once the wood has been allowed to weather after applying Seasonite restore the natural colour of the wood using Net-Trol.