Hollow Knight Maske Wyrm Quirrel Game Funny Toy Helmet Resin Maske Halloween Party Cosplay Maske

Product Information

Knight and Hornet’s costume is a black long-sleeved shirt, black pants, black sneakers, black leather gloves, and a blue knight cloak for the Knight, and a black long-sleeved shirt, black pants, black sneakers, black leather gloves, and red poncho cloak for Hornet. This made it easier to make alterations to the mask as well as letting me cover my neck when I wanted to wear just the helmet. The 103 third parties who use cookies on this service do so for their purposes of displaying and measuring personalized ads, generating audience insights, and developing and improving products. If you have a hard time visualising this, look at painted furniture, you will see that the corners or the edges may be a bit lighter or show the original material underneath. So that you want to do is take a piece of paper and try and trace a pattern for the size of the eye hole.

But if you want to be able to actually hold more than a charm in your hands you should attach the gauntlets to some morph suit gloves. I just thread one end through a hole I made in the fabric with a screwdriver and then tied a knot on the other end so the fabric wouldn't go all the way through. And I recommend doing this even if your print came out flawless because of how simple it is to apply extra texture. However I tried a new method of putting black watered down paint into a spray bottle and spraying it all over the chestplate.To paint the paper is rather simple just a couple coats of watered down yellow's and browns across the page to make it look old. To be honest I don't have photos of the painting process of this mask but it came out so well I had to talk about it here. The next alteration that you can make is gluing some "Web Rope" in strips around the arms where the arm armor goes. I start with a base coat of black paint on most of the armor pieces, then dry brush a silver all over the black except this time it was a much stronger dry brush to the point of it barely even being dry brushing. The little bit of silver will paint over the washes and make it look like those edges are worn from being in contact the most.

Very similar to most other armor pieces except this piece is much thicker I used around 10% infill to make sure it wouldn't split. Keep an eye on filament make sure it doesn't run out, Make sure the print doesn't fail mid way (If there are small gaps they won't matter and I'll explain why in a second), and finally make sure to keep an eye as each part is printing. The way I threaded my ribbon through the channel is by tying it to a long chopstick, then pulling the fabric down over the chopstick until it came through out of the other side, then I untied it from there. These 4 or 5-star reviews represent the opinions of the individuals who posted them and do not reflect the views of Etsy. Put 1-2 piece of Velcro on each piece of armor and then mark where the corresponding spot on the morph suit is in silver sharpie.Now morph suits are designed so that you can see through them when stretched but since the fabric I used to cover the eyes in the helmet obscured my face I couldn't see too well through the black see through fabric, so the solution is to cut a hole in the mask part of the morph suit. Soon after I gave 3d modelling a tried to model a helmet I could wear of the Hollow knight, to go with the sword. They should be made of the same material as the suit so they'll blend right in when you wear the suit.

To attach the "Web Rope" I used hot glue on one end and wrapped it around loose enough so that my arm could still slip out. You can put a sheet of baking paper under the morph suit to prevent glue burns when attaching the "Web Rope".

And as you can see in the photos I did this process all over with black and brown paints making sure to dab it all off after being applied. Once the belt is painted (or not) it is time to add these little ropes bridges (using the "Web Rope"). Just make sure to monitor the prints and keep a steady flow of filament in the printers to make sure you don't need to restart a print.