Airbag SRS warning light resistor 3R3 ohms (5 pack)

Product Information

In the US, having airbag warning lights isn’t illegal, although laws vary from state to state. In the UK, however, having the airbag light on or even flashing is an MoT failure, meaning your car can’t legally drive on the right. Also, in a lot of cases, your car will automatically disable the rest of its airbags when any airbag is causing a warning light. Which could be dangerous. So, here’s how to turn off your airbag warning light. Some vehicles will require the use of a diagnostic scan tool along side the resistance tool as you may need to erase the fault codes until the light goes out. Maybe you keep having an airbag light come on, perhaps you have fitted an aftermarket steering wheel, maybe you are tired of the seat side airbag connections failing. Of course, there are other possibilities such as wishing to use aftermarket seatbelt reels or you don’t want to pay for an airbag but you want the car to pass an MOT. This video will show you step by step instructions on how to make a DIY airbag tester so you can test your airbag without the need for an expensive airbag tool.

I've had a look under the passenger seat but plug all looks connected up and secure. Seat belt hasn't retracted and can still be used.Curve the wire just before the resistor and measure the length between the other end of the resistor and the tip of the needle we just weld. I tried putting a 2.5 ohm resistor in the plug instead of connecting it to the new airbag but light still comes on.

Put some of the smaller heat shrinking tubes over the soldered portion of the needles and the resistor.

Best Snow Foam Lance In 2023

Because to measure resistance, your multi-meter “sends” a reference current through the positive and measures the resulting current after the resistance. Depending on the car model and multi-meter model, the reference current could be high enough to deploy the airbag, which could be potentially deadly or harmful (trust me, if you never saw an airbag deploy before, you don’t want to be holding it when it happens)!

Mod Details Premium Yes Difficulty Mod ID 1104 Credit evilution For Link https://www.evilution.co.uk/mod/airbag-delete-resistor.htm Copy to Clipboard I have been struggling to find information due to the sheer amount of different vehicles and all the results I can find are either for newer models or for pretensioners on the receiver stalk rather than on the belt. If this light is on, none of the safety features will function when required to do so. In a crash, none of the airbags will fire and the seatbelts will not pretension. How Does It Know?You can test your resistor first to make sure it suits your needs. It should be between 2 and 2.4-2.6 ohms.) For example, if you were carrying out diagnostic work on a seatbelt pretensioner circuit and needed to know the correct resistance valuein that circuit then this tool would help you identify it. Il aide au diagnostic d'un airbag défaillant, d'un ressort d'horloge d'airbag et de tendeurs de ceintures de sécurité défaillants, etc. Cut the bigger shrinking tube about half of the total length from the resistor to the needles and insert it over the two wires leaving only the two needles out.