Engine Stop Kill Switch Control, Engine Stop Switch Durable Stable Performance Portable for GX390 Engine

Product Information

When you start your lawn mower or small engine, you turn the flywheel and its magnets pass the coil (or armature). This creates a spark. The ignition system coordinates the timing so that the spark will ignite the air-fuel mixture in the combustion chamber just as it reaches maximum compression in each engine cycle- thus, maximizing the engine’s power. Pressing and holding this switch will activate the headlight high beam. The light will return to the low-beam position after the button is released. This feature can be used to signal other drivers. Mode Switch Some ATVs use a mechanical lever to switch between 2×4 and 4×4. Hand and Seat Warmer Switch (If Equipped)

The mode switch allows you to toggle through your speedometer’s various display modes and functions. These features vary between different ATV brands and models but may include a trip counter, battery voltage, engine rev counter, and odometer. Reverse Override Switch

Starter button pretty much the same. But, to do both, you could run a single positive (switched) to the tiller position and connect it to buttons for the stop and start, the two outgoing wires go to the stop solenoid and starter relay respectively.

To recalibrate the ECU, one should take a nice long ride to get everything up to temp and upon returning home, do not shut it off, but let it idle for 10-15 minutes whiteout touching the throttle or anything else, by this time the cooling fan should be running all the time or most of the time ( unless it is cool outside), doing this will allow the ECU to recalibrate to the best settings for the current condition. I'd guess that anytime you have a drastic change in altitude or climate this would be a recommended procedure to get the best performance form the engine. Depending on how lazy you are getting, you can also do something with the ignition switch. Disconnect the outgoing "ignition" wire and connect it to a latching relay. Fit a momentary push button to the panel, which, when pressed will open/close the relay. You can then parallel this button to the tiller position with the other two buttons. The key switch below would only be used to start the engine, although you could of course remove it and fit a button/switch.Depending on your ATV’s transmission, it may have an electric 4X4 switch that toggles between 2X4, 4X4, and other modes such as 4X4 ADC or other model-specific transmission modes and features. The ignition system is the starting system for your small engine. Whether you start the engine with a pull rope or the turn of a key on an electric start motor, you're relying on the ignition system to produce a spark inside the combustion chamber.

Please continue reading to learn more about how each control mechanism works and what it does. Throttle Lever Press the throttle lever to increase engine speed and vehicle movement. Release the throttle lever to reduce engine speed and vehicle movement. All iOS devices running iOS 8.1 or later are supported. This includes models from iPhone 4s to 6s and from iPad 2 to iPad Pro. Once the engine is running, the flywheel keeps rotating, the magnets keep passing the coil and the spark plug keep firing based on a specific timing. While there are multiple ways to operate the technology, they all involve some form of switch. The reason to hide the kill switch is so no one else knows where it is. If they know there’s a kill switch, they won’t have trouble starting your vehicle. Different types of kill switches involve different levels of installation and operation. 5 Types of Kill Switches

Honda Stop Switch 1 Wire

Use this switch to start and stop the ATV. Insert the correct key to turn the switch. The switch typically has three or four positions: With car thefts on the rise, it’s important to take every step possible to prevent your vehicle from being stolen. One preventative measure may be to install a kill switch in your vehicle. These simple devices ensure your car doesn’t get snatched out from underneath you. But, what type of kill switch should you install to prevent car theft? By activating the reverse override switch, you temporarily deactivate the rev-limiter as long the button is pressed. Use this switch with caution. It’s easy to lose control of the bike while driving fast in reverse. Winch Switch