Grit 5000 Wet And Dry Sandpaper P5000 Waterproof Sanding Sheet Sand Paper

Product Information

It is possible to sandpaper glass without scratching it if you use the right material for the job. This means using the right sandpaper and the right grit. For example, when sanding down a rough glass surface to make it smoother, you’ll need to start with a wet 60-80 grit option and move to finer grits as you work. Move to a finer grit and repeat the process until the edge is smooth enough. The grit progression after using a coarse 80-grit is 150-grit, 320-grit, and 400-grit. Work from one end to the other. Don’t leave the tool running on the surface, as is the case when using a power sander.

Set the tool to a medium speed level. The exact level that qualifies as medium will vary from one model to another. Work in a circular motion, adding some downward pressure where necessary. Maintain even pressure during sanding to ensure uniform sanding. Wipe off the surface from time to time to see the progress you’ve made. Switch to a finer grit when you’re satisfied to complete the sanding process. What Type of Sandpaper Is Best for Glass? You can sand glass, but instead of standard sandpaper, you’ll need to use a diamond sand pad. The necessary grit type will vary from 80-3000 depending on the project. However, sanding glass is not always the best solution; you may wish to consider cutting the glass or finding a smaller piece. Line a portion of the work surface with foam rubber and place a float glass over it. You can use any piece of glassware you don’t need as the float glass. You’ll grind the edge you’d like to work on against the float glass, while the foam rubber is useful for keeping the glass in place.

Hold the glass down with your hand, protected by safety gloves and goggles. For glass pieces with multiple edges, hold them in a way to avoid cuts and piercings. (If this is not possible, explore other options for securing the glass before starting the next step.) Keep in mind, if you can cut the glass down to size or replace it so you can start with a smaller piece, it’s best to explore those options first before sanding glass. For context, it can take hours to sand down tiny amounts of glass, whereas local hardware stores can cut glass in a few minutes. Can You Sandpaper Glass? Will It Cause Scratches?

Map out the frosted shape you’re going for using a permanent marker. (You can erase any mistakes with some cotton swab dipped in some nail polish remover.) Some people keep the surface and sanding pad wet by working under running water (source: Glass Etching Secrets). After you’ve completed the initial sanding, turn off the Dremel and swap out the sanding bit for a finer grit option. Use this to go over the surface again for a smooth and polished appearance. How To Sand Glass by Hand Unwrap the tape and wipe away any remaining tracing lines to get a frosted look on the glass surface.Grab the piece of glass you’re working on and place the edge directly over the spot with silicon carbide and water mix. Regardless of the grit you choose, you need to keep the sandpaper wet at all times. Dry-sanding glass is very counterproductive. How To Sand Glass for a Frosting Effect