5" Thick Insulation Foam Pink

Product Information

As it is non-combustible, it won’t catch fire and therefore won’t contribute to the spread of fire through a building. One end of the microscopic anti-static molecule protrudes from the material edge and draws in moisture from the ambient air to allow a conductive path for current to pass through.

Fire rated foam is often misused due to poor understanding of its suitability. It is important to note that it should only be used to fill small linear gaps, gaps between a door frame and wall and small holes in fire walls. This additive will then slowly migrate to the edges of the foam before forming lines on the surface. A common mistake is for fire rated foam to be used in situations where intumescent sealant is better suited.There is not a one standard does all for expanding fire foams, as they have been tested differently. When pink foam has been used on a timber structure the results will bf foams in timber structure the results will be un achieve satisfactory fire-resistant results. Some fire-resistant foams are specifically designed and tested to fill larger gaps. Closely follow the conditions of use stated in the certification if installing a fire-rated foam product Expanding Foams are not an intumescent, it cannot close or crush a plastic pipe and should never be installed as such.

Fire rated foam is not suitable for use around pipe and cables as it doesn’t intumesce or expand in extreme heat so the services would burn away and leave a void and thus breach the fire compartment. It is the responsibility of the installer and individual responsible for the property to ensure that the product selected is suitable for its intended purpose. Manufactured to include an anti-static additive, these pink foams give a surface conductivity that will reduce over time. Glycerol Monostearate (GMS) is a commonly used additive (although other similar chemicals are also used), which is introduced during the extrusion phase of the material manufacture.It is recommended by ASFP, BMTRADA, FIRAS, IFE that any installations of pink foam are removed and replaced with a true fire rated alternative due to it being difficult to trace the product without chemical composition testing. Fire rated foam is usually pink in colour, to identify it as different from other types of expanding foam which don’t have the non-combustible qualities. When would you need fire rated foam? Fire foams are usually tinted pink to distinguish them from other foam products but they're not all the same - read the instructions

Fire foams are usually tinted pink to distinguish them from other non-fire rated foams, but they’re all different and have varying functions and properties - make sure you’re using the right one. This type of foam typically has a volume resistivity in the range of 10 10 – 10 12 ohms.cms and often has a surface resistivity that is higher still. Some Foams can only provide fire resistance (surface spread of flames) and cannot provide any means of fire integrity depending on manufacturer.

What’s the difference between fire rated foam and intumescent sealant?

Pink Foams especially should be avoided as there is no way after the installation to identify the manufacturer or product used. 10 things to remember about Pink Foam Intumescent sealant, on the other hand, does not expand when applied, and only swells up when a fire has broken out and it reaches a certain temperature. In this circumstance, the sealant will then expand and seal a hole to reinstate a wall or door’s fire containment properties. Polyurethane (PU) foam fillers - also known as ‘fire foam’ - are common in construction, but if you use them without properly understanding them they can end up costing you money, creating worse fire risks, and potentially ruin your hard-earned reputation. Depending on the product and conditions of the fire it can also produce toxic fumes causing permanent health damage.