RED5 Motion Controlled Drone

Product Information

Rather than trying to reinvent the wheel, [Paweł] decided to implement his motion controller as an add-on for OpenTX hardware like the RadioMaster TX16S. If you have just replaced your blades, be careful you haven't put your brand spanking new ones on too firmly, as this can stop the motors spinning freely (or even at all).

All flight locations displayed by the Fly Spots feature are based on voluntarily-shared location tags from SkyPixel users. Trimming is a critical part of flying a drone so always read your instructions to find out where the controls are to do this! DJI Care Refresh (DJI FPV) is a service plan that provides you with greater peace of mind during flight. You can also hold the Motion Controller and twist/rotate your forearm to the left or right to make a turn. The powerful and intuitive DJI RC Motion 2 provides convenient and responsive control, allowing even beginners to quickly enjoy the fun of motion-based flight control.

The USB-C port at the bottom of the Motion Controller can be used to charge the device and connect to a computer for firmware updates.

You might not believe this, but one of the most common reasons for a rotor not spinning is trapped hair! Always follow local rules and regulations and fly your drone within your visual line of sight unless otherwise permitted. Too little power and you are going to get tubulence from the drone being too close to the ground, so it's going to be very hard to control. degree flips:To do this, all you have to do is simply push the trigger on the side and the drone does the rest for you. A new way to fly: Gone is the complicated remote and in comes a computer mouse styled gadget that works with the motion of your hand.This system receives flight location information from airplanes and helicopters in your area that transmit ADS-B signals, and warns you through the Goggles V2 so you have time to avoid those aircraft.

Outside of the motion sensing gear, the ESP32-powered peripheral also has a thumb stick and a pair of push buttons nestled into its 3D printed frame.

Unwilling to get locked into the DJI ecosystem, [Paweł Spychalski] has developed an open source work-alike motion controller that brings gesture flying to home-built quadcopters and airplanes.

Check the goggles interface to make sure there are no warning prompts and that GPS signal is adequate. You've just bought your brand new drone and the only thoughts on your mind are how high you can get it, how fast you can go, and what totally awesome tricks you can pull of mid flight! Auto take-off and land: Getting the drone up in the air or getting it to land safely might seem easy, until you try it and then reality hits. TIP: Before updating the firmware, make sure the battery level for both the aircraft and remote controller is above 50%, and a stable internet connection is available. Now you don’t need to worry about which way the drone is facing and trying to figure out the correct command to give it.

The gimbal camera, landing gear, and top shell of the DJI FPV aircraft are all modular and easily replaceable, making repairs more convenient. It's perfectly normal to have to trim a drone at some point during its flight, and that's why all drones have trim adjustments on them.